More information

About EN 10025:3 S460NL Steel Plate

  • Documents icon

    The designation of the EN 10025:3 standard for S460NL shows that this is steel for structural purposes (S), with a minimum yield strength of 460 MPa (460) at 16mm thick and below. This classification has specified minimum impact energy values at temperatures not lower than -50 deg C (NL).
    As well as S460NL we are stockists of plates to EN 10025:3 S460N.

Applications


  • Bridges
  • Grouted tees/grouted sleeves
  • Pipe caps/pipe fittings
  • Pipe lines
  • Plate girders
  • Pressure vessels
  • Road tankers

Properties

Chemical Requirements
(cast analysis, % by mass, maximum permitted unless indicated otherwise)

c Si Mn P S Al total N Cr Cu Mo Nb Ni Ti V NB+Ti+V Mo+Cr
0.20 0.60 1.00 – 1.70 0.025 0.020 0.020 min 0.025 0.30 0.55 0.10 0.05 0.80 0.05 0.20 0.22 0.30

Tensile Requirements

Product thickness Yield strength (MPA) min Tensile strength (MPA) Elongation min
up to 16mm 460 540 – 720 17
16mm to 40mm 440 540 – 720 17
over 40mm to 63mm 430 540 – 720 17
over 63mm to 80mm 410 540 – 720 17
over 80mm to 100mm 400 540 – 720 17
over 100m to 150mm 380 530 – 710 17
over 150mm to 200mm 370 530 – 710 17

Impact energy values for the normalised condition
Longitudinal

-50°C -40°C -30°C -20°C -10°C 0°C +20°C
27 J min 31 J min 40 J min 47 J min 51 J min 55 J min 63 J min

Impact energy values for the normalised condition
Transverse

-50°C -40°C -30°C -20°C -10°C 0°C +20°C
16 J min 20 J min 23 J min 27 J min 30 J min 34 J min 40 J min

Request product data sheet

Get in Touch